{"page":{"id":117742502172,"body_html":"\u003ch1\u003eAnderson Excalibur Knob Instructions\u003c\/h1\u003e\u003cbr\u003e\n\u003cp\u003eYour new Anderson knobs will replace stock knobs on the Minelab Excalibur. They are larger and also have a pointer.\u003c\/p\u003e\nLoosen the 1\/4' nut and slide off the old knob. Make sure you clean any sand or dirt from the shaft before installing the new knobs.\n\u003cp\u003e \u003c\/p\u003e\nTo remove the stock knobs you must remove the yellow cap with a small flat screwdriver to expose the nut. Make sure the pointers on the knobs align with the proper location on the detector. Use a small standard screwdriver to tighten the set-screws. Note: do not over-tighten the set-screws as this may damage the knobs or shafts.","created_at":"2023-05-23T11:41:56-04:00","published_at":"2021-02-16T21:42:44-05:00","updated_at":"2023-08-17T10:14:08-04:00","handle":"instruction-manuals__anderson-documentation__anderson-excalibur-knob-instructions","title":"Anderson Excalibur Knob Instructions"}}