- Make sure your detector is on. *Important - For optimal performance, be sure that the headphones' blue LED and detector are on the same side.
- While pressing the white button on the headphones, switch the on-off button of the headphones to ''on'' position and do NOT let go of the white button until the beep indicating the battery status is heard.
- Headphones will emit a number of beeps to indicate the battery status as follows: Five (5) beeps for fully charged battery Four (4), three (3), two (2) beeps to indicate diminishing charge One (1) beep if the battery is low. When the battery is approaching full depletion, the headphones will start emitting continuous beeps at short intervals indicating an immediate need to charge the battery. IMPORTANT! Disconnection and unpairing may occur when the battery is low!
- The blue LED on the other side will start blinking every 2 seconds.
- Press the plus (+) and minus (-) buttons on your detector at the same time. A high beep will be heard.
- The blue LED on the headphones will start to blink every second, the wireless icon will appear on screen and the wireless headphones will pair with the detector.
- Once the pairing is successful, if you experience any distortion in the audio or interference from another detector, change the channel by selecting the wireless connection setting on your detector and using the plus (+) and minus (-) buttons. Channels will change between 1-5. At 0 position, the wireless connection is off. When you are not using the wireless headphones, keeping the wireless setting at 0 position is recommended.
- Once the pairing is complete, the headphones and the detector will connect automatically at the next start-up.
- To adjust the volume, use the volume setting of the detector.
Leave a Reply
Your email address will not be published. Required fields are marked *