Anderson Excalibur Knob Instructions


Your new Anderson knobs will replace stock knobs on the Minelab Excalibur. They are larger and also have a pointer.

Loosen the 1/4' nut and slide off the old knob. Make sure you clean any sand or dirt from the shaft before installing the new knobs.

 

To remove the stock knobs you must remove the yellow cap with a small flat screwdriver to expose the nut. Make sure the pointers on the knobs align with the proper location on the detector. Use a small standard screwdriver to tighten the set-screws. Note: do not over-tighten the set-screws as this may damage the knobs or shafts.