Stork Carbon Fiber Shaft for Minelab Equinox Metal Detector

Stork Carbon Fiber Shaft for Minelab Equinox

Stork Carbon Fiber Shaft for Minelab Equinox

• Glides through the water like you have never experienced.
• Light, strong and rigid
• Only .40 pounds
• Bolts (for maximum rigidity) directly to your Equinox 600 or 800 with the supplied Stainless screws, with or without the plastic knobs.
• Included are colored knobs/screws which you might like. Yellow is 6mm and screws the upper handle and the red is 1/4-20 for the mid-shaft. Be sure not to mix up the screws: The finer thread 6mm screws for the upper connection and the 1/4 course thread for the midsection.
• The lower tear drop-shaped rubber washers are larger than the original Minelab. 2 spare washers are supplied in case you wear the original set out in a year or two.
• You should use your original coil screw and nut but we have included a spare nylon screw and wing nut just in case.
• Carbon Fiber Mid and Lower shaft
• A premium roll of 3M black tape is included so you can seal all holes and joints so sand will not enter and freeze up your shafts.
• The Mid shaft is 3/4" in diameter, smaller than the 20mm original
• The lower shaft is 10mm in diameter (just over 3/8")
• We provide a 3-year warranty if you seal all holes and joints with black electrical tape (supplied) so sand will stay out of the joints.
• MADE IN THE USA