Pairing Wireless Headphones with the TMD-101

How to: Pair the Nokta Makro Wireless Headphones (Green) to the TMD-101

in Serious Detecting Blog
How do I pair my Nokta Makro 2.4GHz Wireless Headphones (Green) to the TMD-101?
  1. Make sure your detector is off. *Important - For optimal performance, be sure that the headphones' blue LED and detector are on the same side.
  2. While pressing the white button on the headphones, switch the on-off button of the headphones to the ''on'' position and do NOT let go of the white button until the beep indicating the battery status is heard.
  3. . Headphones will emit a number of beeps to indicate the battery status as follows: Five (5) beeps for a fully charged battery Four (4), three (3), two (2) beeps to indicate diminishing charge One (1) beep if the battery is low. When the battery is approaching full depletion, the headphones will start emitting continuous beeps at short intervals indicating an immediate need to charge the battery.
  4. The blue LED on the other side will start blinking every 2 seconds.
  5. Turn the detector on while pressing the sensitivity plus (+) button and do NOT let go of the button until the wireless icon appears at the bottom of the screen.
  6. When the pairing is successful, the audio will be heard through the headphones and the blue LED will start blinking about every second. In addition, the wireless icon will appear steady. If the pairing is not successful, the wireless icon will start blinking. In such a case, repeat the above steps.
  7. Once the pairing is successful, if you experience any distortion in the audio or interference from another detector, press the M button for 3 seconds while the detector is on. The frame indicating the selected mode will start blinking. Change the channel by using the volume plus (+) and minus (-) buttons. Bars will rise or fall indicating channel change. There are a total of 20 channels. If the bar is empty, it means that the wireless connection is off. When you are not using the wireless headphones, keeping the wireless connection off is recommended.
  8. Once the pairing is complete, the headphones and the detector will connect automatically at the next start-up.
  9. To adjust the volume, use the volume setting of the detector.


Leave a Reply

Your email address will not be published. Required fields are marked *