Getting your Nokta Makro 2.4GHz Wireless Headphones (Green) connected to the TMD-101 is straightforward once you know the steps. These headphones work across multiple Nokta detector models and deliver reliable wireless audio for your detecting sessions.
Quick Setup Requirements
Before starting the pairing process, you'll need your detector turned off and the headphones ready. The blue LED position matters for optimal performance - keep it on the same side as your detector's control box to avoid interference.
Step-by-Step Pairing Process
Start with detector off. For best performance, position the headphones so their blue LED and detector are on the same side.
Activate headphone pairing mode. While pressing the white button, switch the headphones to "on" and hold the white button until you hear the battery status beep.
-
Check battery status. The headphones will emit beeps indicating charge level:
Five (5) beeps: Fully charged
Four (4), three (3), two (2) beeps: Diminishing charge levels
One (1) beep: Low battery
Continuous short beeps: Immediate charging needed
Watch for blue LED. The LED will start blinking every 2 seconds when ready to pair.
Enable detector wireless mode. Turn on the TMD-101 while pressing the sensitivity plus (+) button. Hold until the wireless icon appears on screen.
Confirm successful pairing. Audio should come through headphones, blue LED blinks about every second, and wireless icon shows steady. If the wireless icon blinks instead, repeat the process.
Channel Selection and Interference
The TMD-101 offers 20 wireless channels to avoid interference from other detectors. If you experience audio distortion or interference:
Press M button for 3 seconds while detector is on
Mode frame will start blinking
Use volume (+) and (-) buttons to change channels
Rising/falling bars indicate channel changes
Empty bar means wireless connection is off
When not using wireless headphones, keeping the connection off saves battery life on both devices.
Volume Control and Auto-Connection
Volume adjustment happens through the detector's controls, not the headphones themselves. Once successfully paired, your headphones and TMD-101 will automatically connect at startup - no need to repeat the pairing process.
Why Choose Wireless for Metal Detecting
Wireless headphones eliminate cord snags on brush and equipment, especially important when using metal detector accessories like pouches and diggers. The 2.4GHz frequency provides reliable range without the Bluetooth lag that can mask subtle audio cues.
Other manufacturers like Garrett offer similar wireless solutions through their Z-Lynk technology, while Nokta Gold Kruzer and Nokta Impact models also support these same wireless headphones.
Troubleshooting Common Issues
If pairing fails repeatedly, try these steps:
Ensure both devices are fully charged
Move away from other wireless devices during pairing
Check that you're holding the white button throughout the entire startup sequence
Verify the sensitivity (+) button is pressed during detector startup
