XP Deus Standard 9-Inch New Version Search Coil Cover

This coil cover fits the XP Metal Detectors new-version Standard 9-inch DD coil, identifiable by the longer XP logo that extends from the coil tip nearly to the coil ears. It also fits the Deus II 9-inch FMF round coil, the Deus X35 9-inch round coil, and the Deus HF 9-inch round coil. The key identifier is the new-style housing with the extended logo, which differs from older Deus coils with shorter branding. If your 9-inch Deus coil has the longer logo placement, this cover will snap on securely.

The new-version XP Deus 9-inch coil has a longer XP logo that runs from the tip of the coil nearly to the coil ears, while the old-version coil has a shorter logo positioned closer to the center. Look at the top surface of your coil: if the logo extends most of the length toward the mounting ears, you have the new version and this cover will fit. If the logo is compact and centered, you have the older style and need a different cover. The housing design also differs between versions, so the extended logo is the most reliable visual identifier for compatibility.

This coil cover does not affect detection depth or sensitivity on the XP Deus platform. The reinforced polymer material is non-metallic and thin enough that it sits safely outside the coil's electromagnetic field—a crucial factor when dealing with highly sensitive metal detector technologies. Signal transmission and ground balance remain unchanged. We've run side-by-side depth tests on air-test targets and buried coins with and without the cover installed, and the results are identical. The cover adds negligible weight, so swing fatigue stays the same.

Installing the XP Deus 9-inch coil cover takes under 30 seconds with a snap-on fit. Align the cover's mounting tabs with the coil housing, starting at the tip and working toward the ears, then press firmly around the perimeter until you hear or feel the cover snap into place. No tools or adhesive are required. The cross-pattern tread should face downward toward the ground. To remove the cover for cleaning or inspection, peel it off starting from one edge and work around the perimeter. The cover stays secure during aggressive ground scrubbing but removes easily when needed.

No, this cover is designed specifically for 9-inch round XP Deus coils and will not fit the elliptical coil shapes offered for the Deus II. The Deus II elliptical coils have a different housing geometry that requires a dedicated elliptical cover. This cover fits only the round 9-inch coils: the new-version Standard DD, the Deus II 9-inch FMF, the X35 9-inch, and the HF 9-inch round coils. Check our wider selection of metal detector parts & accessories for elliptical-specific covers if you run those coil shapes.

The XP Deus 9-inch coil cover uses thin reinforced polymer construction, measured at the flat sections between the cross-pattern ridges. The reinforced rim is slightly thicker to absorb edge impacts from rocks and curbs. This construction provides meaningful abrasion protection without adding noticeable weight or altering the coil's ground clearance. The material flexes slightly on impact to absorb shock rather than transferring the force directly to the coil housing, which prevents stress cracks over time. We've run these covers through hundreds of hours of rocky-ground hunting, and the polymer shows deep scuff marks while the coil underneath remains undamaged.

This cover is designed for the new-version XP Deus 9-inch coil with the extended logo, which was introduced after the original Deus coils. The original Deus coils have a different housing shape and logo placement, so this cover may not fit securely. If you own an early Deus coil, check the logo length: if it extends nearly to the coil ears, this cover will fit. If the logo is short and centered, you need the older-style cover designed for the original housing. Contact an authorized XP dealer to confirm the correct cover for your specific coil version.