The Nokta Makro Gold Finder 2000 assembly process is straightforward when you follow the correct sequence. This Nokta metal detector requires careful attention to avoid overtightening components that could damage the threads or interfere with performance.
Essential Assembly Steps for the Gold Finder 2000
Before starting assembly, lay out all components on a clean surface. The Gold Finder 2000 features a three-piece shaft system similar to other gold finder metal detectors in the Nokta lineup.
- Coil and Lower Shaft Connection: After inserting the washers on the lower shaft, place the lower shaft in its location on the search coil. Secure by tightening the screw and nut. Do not overtighten as this can strip the threads or crack the coil housing.
- Shaft Assembly: To join the middle rod with the upper and lower rods, open the lever latches and engage the pieces together. After adjusting the length of the device to your height, press the latches to secure. The cam levers should snap firmly into place.
- Cable Management: Wind the search coil cable on the shaft without stretching too much. Excessive tension can damage the internal wiring over time. Then, plug the connector to the search coil input socket on the system box and secure by tightening the nut. While tightening, you may hear clicks indicating that the connector is secured.
- Armrest Adjustment: To adjust the armrest to your comfort, push the red lock forward. Adjust it by sliding it up or down and secure by pushing the red lock in the opposite direction. Insert the armrest strap as shown in the picture and adjust it to your arm size and tighten.
Proper Length Adjustment for Gold Detecting
Unlike general-purpose metal detectors, the Gold Finder 2000's shaft length affects your ability to maintain the coil parallel to the ground during slow, methodical sweeps typical of gold prospecting. Set the detector so your arm hangs naturally at your side with a slight bend at the elbow.
The shaft should extend to approximately your wrist level when standing upright. This positioning reduces fatigue during extended gold hunting sessions and maintains optimal coil control.
Cable Routing Best Practices
The coil cable routing on the Gold Finder 2000 requires attention to prevent interference. Route the cable along the underside of the shaft, securing it with the provided cable ties at regular intervals. Avoid creating tight loops or sharp bends that could cause signal issues.
The connection at the control box should seat completely before tightening the locking ring. A properly seated connector will have no visible gap between the connector body and the socket.
Armrest Setup for Extended Use
The armrest position directly affects comfort during long detecting sessions. Position it so your forearm rests naturally without forcing your wrist into an awkward angle. The red lock mechanism should engage fully - a half-locked position will allow the armrest to slip during use.
Adjust the strap tension so you can easily lift your arm from the detector without it falling, but loose enough that circulation isn't restricted during extended gold hunting sessions.
Assembly Troubleshooting
Shaft Won't Lock: If the cam levers won't close completely, don't force them. Slightly adjust the shaft extension until the levers seat properly. Forcing can bend the locking mechanism.
Loose Coil Connection: The coil should mount firmly without wobbling. If there's play in the connection, check that both washers are properly seated and the bolt is tightened to snug, not maximum torque.
Cable Issues: The coil cable should route cleanly without binding when you swing the detector. If the cable pulls tight during normal sweeping motion, re-route it with less tension.
Final Assembly Check
Before your first hunt, test all adjustment points. The shaft should extend and retract smoothly, the coil should remain parallel to the ground during a normal sweep, and the armrest should support the detector's weight comfortably.
Check the control display setup in our Nokta Gold Finder 2000 Quick Guide to Control Display to complete your detector setup.
Maintenance After Assembly
Once assembled, periodically check all connection points for looseness, especially after transport or extended use. The Gold Finder 2000's adjustable components can work loose over time, affecting performance and potentially causing damage if left unchecked.
